Fuse Tech has the capability to cut through refractory walls and crowns with a diamond chainsaw while the production unit is in operation. This service is used to provide access holes for Fuse Tech’s Ceramic Welding Service as well as providing additional opening in furnaces for peepholes, oxy fuel conversions, drain or tapout openings and expansion joints, or anywhere openings or modifications are required. Not only do weprovide our own access openings, but we also employ masons with many years of experience to brick in and seal the openings when we are finished with repairs inside the furnace or vessel. Ask about our experience, you will be impressed!
The latest addition to the Fuse Tech / Hot Tech refractory cutting equipment is the water-cooled ring saw. This saw allows straight accurate cutting both vertically and horizontally on both hot and cold walls. When possible a wall-cutting rail is used to allow very accurate straight level cuts. If the wall is thicker than 10″ the initial cut is made with the ring saw for accuracy and the remaining material would be cut using the conventional water-cooled diamond chain saw.